The wellhead joint is used to connect the blowout preventer and the wellhead, the upper part is connected with the blowout preventer, and the lower part is connected with the wellhead.
Wellhead joints are sealed by threads. When in use, wrap the thread with PTFE tape or apply anti-sticking grease on the thread, and then directly tighten the wellhead joint on the thread of the wellhead.
The wellhead joint shall be subjected to compressive strength test regularly, and the test pressure shall be 1.5 times of the working pressure.
1. Install the pressure test connector and connect the pressure test pipeline;
2. Start the pressure test pump for pressure test: press to the test pressure, keep the pressure for 15 minutes without leakage, and fill in the test record card.
1. Pressure test should be carried out regularly;
2. When not in use temporarily, you should bring the protective wire for storage.