+86-13571793445       selina@rxwirelinetools.com
You are here: Home » Products » Running & Pulling Tools » GS Pulling Tool
Share to:

GS Pulling Tool

A GS pulling tool is used to pull inner fishing necks, which can cut off and release an object downward and is usually is used to throw and fishing the lock cylinder, packer, bridge plug and others with inner fishing necks.
Availability:
  • 1.5inch 2inch 2.5inch 3inch 3.5inch 4inch 5inch 6inch 7inch
  • Ruixin
  • GS Pulling Tool
  • Alloy Steel&Nickel Alloy
  • China Baoji
  • Wireline Operation And Slickline Operation
  • Standard

GS Pulling Tool Manufacturer - Ruixin

The GS pulling tool is used to pull inner fishing necks, which can cut off and release an object downward and is usually is used to throw and fishing the lock cylinder, packer, bridge plug and others with inner fishing necks.

GS Pulling Tool Introduction

After connecting the GU joint (upward shear joint), it can be converted to be an upward shear and releasing tool.

GS Pulling Tool General Technical Parameters

Size

Actual OD

Fishing neck

Fishing diameter

Connection

1-1/2″

1.47″

1.187″

1.06″

15/16″-10UN

2″

1.81″

1.375″

1.38″

15/16″-10UN

2-1/2″

2.25″

1.375″

1.81″

15/16″-10UN

3″

2.72″

2.313″

2.31″

1-1/16″-10UN

3-1/2″

3.11″

2.313″

2.62″

1-1/16″-10UN

4″

3.62″

2.313″

3.12″

1-1/16″-10UN

5″

4.5″

3.125″

4″

1-1/16″-10UN

6″

5.56″

3.125″

4.75″

1-1/16″-10UN

7″

5.83″

3.125″

5.38″

1-1/16″-10UN


Note: More customized parts are available upon request.

GS Pulling Tool Structural features

The GS pulling tool is mainly composed of fishing neck, shear pin seat, main spring, spring seat, secondary spring, fixed seat of claw, skirt, fishing claw, mandrel, etc..

While the tool is fishing and when the fishing claw just touches the mouth end of the inner fishing neck, it will retreat and fall in the position where the mandrel diameter is a little small and then is taken back; after the fishing claw enters into the inner fishing neck completely, the fishing claw will splay immediately with the thrust of compressed secondary spring.

While throwing it and when the skirt withstands the end face of the inner fishing neck, the tool will move downward can cut off the shear pin because of the relative motion of mandrel and shear pin seat; under the function of main spring and spring seat, the fishing claw and mandrel have relative motion and then the fishing claw withdraws.

The fixed seat of claw can make the fishing claws distributed uniformly and act synchronously.

GS Pulling Tool Maintenance

1. After disassembling the tool, inspect the damages of all parts and change the damaged parts.

2. While assembling the tool, the thread surface shall be painted with a thin layer of grease.

3. After assembly, the connection threads of fishing neck shall be protected with thread protector and marked for standby application.

47.GS Type Pulling ToolsGS投捞器






Previous: 
Next: