Slickline Tool Trap Wireline

Slickline Tool Trap Wireline Manufacturer - Ruixin

It is a safety device to prevent the tool string from accidentally falling into the well when the tool string is pulled out.

Slickline Tool Trap Wireline also known as lower catcher.  It is installed below the blowout preventer and above the blowout preventer.

Slickline Tool Trap Wireline The main technical parameters

1. Specification model: FD6.0-35;

2. Minimum diameter: 60mm;

3. Rated working pressure: 35MPa;

4. Strength test pressure: 52.5MPa;

5. Connection thread: Tr78×6;

6. Control mode: manual control.

Slickline Tool Trap Wireline Structural features

The Slickline Tool Trap Wireline is mainly composed of the body and the manual control system.

When working, the steel wire or cable passes through the slot in the middle of the fork of the anti-drop device. When the lifting tool string enters the drop preventer, lift the shift fork into an upright shape. After the tool string passes through, under the combined action of the shift fork eccentricity and the gravity of the handle, the shift fork falls back to the horizontal position, and the tool string is blocked. Inside the blowout preventer to prevent accidental dropping of the tool string.

Slickline Tool Trap Wireline maintenance

1. Do product test every time before going to the well;
2. After each use,
(1). Check whether the o-ring is damaged and replace it in time;
(2). Check whether the manual fork is flexible;
3. When not in use temporarily, you should bring the protective wire for storage.