Wireline Tool Trap

Wireline Tool Trap Manufacturer - Ruixin

Wireline Tool Trap, also known as lower catcher. It is a safety device to prevent the tool string from accidentally falling into the well when the tool string is pulled out. It is installed below the blowout preventer and above the blowout preventer.

Wireline Tool Trap Main technical parameters

1. Specification model: FD7.6-35;

2. Minimum diameter: 76mm;

3. Rated working pressure: 35MPa;

4. Strength test pressure: 52.5MPa;

5. Connection thread: 5-4ACME•O type;

6. Control mode: manual control.

Wireline Tool Trap matters needing attention

1. When the tool string goes down the well, observe that the external handle is up to 90°, and the fork is fully opened at this time, otherwise the tool will be obstructed when going down the well;
2. After the tool string enters the wellhead and completely passes through the fall arrester, the hand pump is used to relieve the pressure.

Wireline Tool Trap daily maintenance

1. Do product test every time before going to the well;
2. After each use, Check whether the o-ring is damaged and replace it in time

3. When not in use temporarily, you should bring the protective wire for storage.