Availability: | |
---|---|
12inch - 20inch
Ruixin
Wireline Hydraulic Stuffing Box
Alloy Steel&Nickel Alloy
China Baoji
Wireline Operation And Slickline Operation
Standard
The Wireline Hydraulic Stuffing Box is a ground pressure control device used to seal the steel wire in the steel wire operation. The sealing of the steel wire is realized by the rubber sealing disc. The BOP system is equipped with a wire-BOP plug to seal the downhole pressure after the wire breaks. The pressing mode of sealing disc is hydraulic remote control and manual.
The Wireline Hydraulic Stuffing Box is mainly composed of three parts: pulley support assembly, body assembly and control cylinder assembly.
Sheave Dia. | Work Pressure | Wire Size | Control Method |
12" | 5000PSI~10000 PSI | 0.092" | Manual & Hydraulic |
14" | 5000PSI~15000 PSI | 0.108" | Manual & Hydraulic |
16" | 5000PSI~15000 PSI | 0.125" | Manual & Hydraulic |
20" | 5000PSI~15000 PSI | 0.16" | Manual & Hydraulic |
Note. More customized parts are available upon request.
1. Tie a knot at the stopper of the blowout preventer after threading the wire through the lower part;
2. Install the pressure test connector and connect the pressure test pipeline;
3. Connect the hand pressure pump line to the control cylinder, and first press to 21MPa; Manual capping can also be used to tighten the sealing steel wire;
4. Start the pressure test pump for pressure test, the test pressure is 70MPa, keep the pressure for 15 minutes, and fill in the test record card.
1. Replace the packing and BOP plug after each well;
2. The bearing should be checked and replaced if it has stuck or abnormal noise;
3. When not in use for the time being, should bring the protective wire storage.
The Wireline Hydraulic Stuffing Box is a ground pressure control device used to seal the steel wire in the steel wire operation. The sealing of the steel wire is realized by the rubber sealing disc. The BOP system is equipped with a wire-BOP plug to seal the downhole pressure after the wire breaks. The pressing mode of sealing disc is hydraulic remote control and manual.
The Wireline Hydraulic Stuffing Box is mainly composed of three parts: pulley support assembly, body assembly and control cylinder assembly.
Sheave Dia. | Work Pressure | Wire Size | Control Method |
12" | 5000PSI~10000 PSI | 0.092" | Manual & Hydraulic |
14" | 5000PSI~15000 PSI | 0.108" | Manual & Hydraulic |
16" | 5000PSI~15000 PSI | 0.125" | Manual & Hydraulic |
20" | 5000PSI~15000 PSI | 0.16" | Manual & Hydraulic |
Note. More customized parts are available upon request.
1. Tie a knot at the stopper of the blowout preventer after threading the wire through the lower part;
2. Install the pressure test connector and connect the pressure test pipeline;
3. Connect the hand pressure pump line to the control cylinder, and first press to 21MPa; Manual capping can also be used to tighten the sealing steel wire;
4. Start the pressure test pump for pressure test, the test pressure is 70MPa, keep the pressure for 15 minutes, and fill in the test record card.
1. Replace the packing and BOP plug after each well;
2. The bearing should be checked and replaced if it has stuck or abnormal noise;
3. When not in use for the time being, should bring the protective wire storage.